 |
4 Slot EZPLC Plus Base (32I/O Max) Standard, 110 VAC Power Input
- Power Supply Capacity: 3.3V @ 1 Amp
- CPU & Support Electronics Power: 300mA
- I/O Module Power: 25mA
- DeviceNet/Profibus Interface Power: DeviceNet 50mA, Profibus 100mA
- Maximum Power Consumption: 10 watts
- CPU Processor: 32 Bit, 40 MHz RISC Processor
- Total Memory: 64 KB (Ladder)
- Total # of Registers: 8192 16Bit
- Typical Scan Time: 3ms (1K Boolean)
- Real Time Clock/ Calendar: Built-in
- Battery Backup: Yes, Lithium coin cell battery with 5 year life expectancy, with a low battery indicator
- LED Indicators: Input Power, CPU Status (Run, Program & Run/Program) , Low Battery and RS232 Programming Port active indicators
- I/O Supported: EZI/O Snap-in modules with status LEDs and Removable Terminal Block: DC / AC / Analog / Relay / Thermocouple / High Speed Counter / DeviceNet / Profibus
- Operating Temperature: -10C to 60C
- Storage Temp.: -20C to 70C
- Humidity: 10-95% Non-Condensing
- Electrical Noise: Nema ICS 2-230 Showering arc; ANSI C37.90a SWC; Level C Chattering Relay Test (pending)
- Agency Approval: UL, CUL, CE (pending)
- Withstand Voltage: 1000VDC (1 minute) between power supply input terminal and protective ground)
- Insulation Resistance: Over 20M Ohm between power supply input and terminal and protective ground
- Vibration: 5 to 55Hz 2G’s for 2 hours in X,Y,and Z axis
- Shock: 10G for under 12ms in the X,Y, and Z axis
- Protocols Supported: ASCII In/Out on RS422/485 port; EZ Protocol on Ethernet and RS232 port
- DeviceNet Slave option card (EZPLC-DeviceNet), and Profibus Slave option card (EZPLC-Profibus)
- Communication Ports - Standard Model:
Port 1: RS232 (Programming and HMI Port Only with EZ Protocol)
Port 2: RS422 (1.2K, 2.4K, 4.8K, 9.6K, 19.2K, and 38.4K Baud Rates supported) ASCII In/Out - Communication Ports - Ethernet Model:
Port 1: RS232 (Programming and HMI Port Only with EZ Protocol)
Port 2: RS422 (1.2K, 2.4K, 4.8K, 9.6K, 19.2K, and 38.4K Baud Rates supported) ASCII In/Out
Port 3: Ethernet TCP/IP with EZ Protocol for programming or interface to an HMI - External Dimensions: 5.75” x 4.868” x 3.124” (146.05 x 123.65 x 79.356mm)
|
|
|
